|
Last Modified: 11-29-2007 |
1.6 J |
|
Service Category: Power Source/Network |
Section: Networking |
|
Model Year: 2008 |
Model: Sequoia |
Doc ID: RM000002VTI002X |
|
Title: NETWORKING: CAN COMMUNICATION SYSTEM: DESCRIPTION (2008 Sequoia) |
|
Air Conditioning Amplifier Communication Stop Mode
|
DESCRIPTION
|
Detection Item
|
Symptom
|
Trouble Area
|
|
Air Conditioning Amplifier Communication Stop Mode
|
When either condition below is met:
-
Air Conditioner is not displayed on "CAN Bus Check".
-
Applies to "Air Conditioning Amplifier Communication Stop Mode" in "DTC Combination Table".
|
-
Power source or inside air conditioning amplifier
-
Air conditioning amplifier branch wire or connector
-
Air conditioning amplifier
|
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
PROCEDURE
|
1.
|
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
|
(a) Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| NEXT |
|
|
|
2.
|
CHECK FOR OPEN IN CAN BUS WIRE (AIR CONDITIONING AMPLIFIER BRANCH WIRE)
|
|
(a) Disconnect the H24 air conditioning amplifier connector.
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection
|
Switch Condition
|
Specified Condition
|
|
H24-11 (CANH) - H24-12 (CANL)
|
Ignition switch off
|
54 to 69 Ω
|
| OK |
|
|
|
3.
|
CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND)
|
(a) Reconnect the cable to the negative (-) battery terminal.
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection
|
Condition
|
Specified Condition
|
|
H24-14 (GND) - Body ground
|
Always
|
Below 1 Ω
|
|
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection
|
Switch Condition
|
Specified Condition
|
|
H24-21 (B) - Body ground
|
Always
|
11 to 14 V
|
|
H24-1 (IG+) - Body ground
|
Ignition switch ON
|
| OK |
|
|
|